Energy welding conditions, the most important thing is the length of time (vibration, welding time) and pressure are applied. , Other conditions are also very important.

     Welding temperature: Welding temperature: When the welding temperature rises, it will not melt if the temperature is low.

     Pressure: Use the fitter's stare to pressure the molded product. The general pressure is 0.1-0.3MPa (pressure), sometimes it will increase. But if high pressure is used, scientific vibration will be applied.

     Welding time: depending on various materials and shapes, the final product must be welded for as long as 0.2 seconds. Notice.

     Cooling time: For crystalline plastics, the temperature will be below melting and continue to cool down. Part of the time will be between 0.1 and 2 seconds.

     Dongguan welding machine requirements: welding head is divided into three parts from top to top, welding head, amplifier and energy device (a transducer). The three are zoomed in at a certain time scale. If the transducer can be converted to 6MM, the amplifier can be amplified three times to 18MM, and the welding head concentration can be increased by 36MM. As the concentration increases, the life of the welding head will be increased. The material to be welded is different, and it is reduced to the same reduction.

     Welding head materials are usually divided into:

     1. Titanium: expensive, best performance, good limbs, difficult to process.

     2. Urgent: cheap, fast energy, can't process more than 30MM, easy;

     3.: Very hard, the most soft welding head, rather than 25mm, cut immediately, need to increase the teaching tube, cooling.